Bottled water types explained
In the US, the words on a bottled water label have legal meanings, set by the FDA in its bottled water standard (21 CFR 165.110). Here's what each one means, with examples from this site.
Spring water
Water from an underground formation that flows naturally to the surface, collected at the spring or through a bore hole into that formation. Spring water keeps its natural minerals, so it varies a lot between springs: compare Poland Spring with Mountain Valley.
Purified water
Water treated by distillation, deionization, reverse osmosis or another process until it meets the US Pharmacopeia's definition of purified water. It can be labeled by its process, such as "distilled water" or "reverse osmosis water". The source is often a city water supply. Many brands then add a little magnesium sulfate, potassium or salt "for taste", as Dasani does. The FDA treats those as a separate, non-standardized product, which must say so on the label.
Distilled water
Purified water made by boiling and condensing the steam, which leaves the minerals behind. It's the closest to zero dissolved solids: see the dissolved solids list.
Mineral water
Water with at least 250 mg/L of dissolved solids, from a protected underground source, whose minerals stay at a constant level and in constant proportions. Nothing may be added. A mineral water under 500 mg/L must say "low mineral content", and one over 1,500 mg/L "high mineral content".
Artesian water
Water from a well into a confined aquifer, where the water stands above the top of the aquifer under its own pressure. Fiji is an artesian water.
Sparkling water
"Sparkling bottled water" must have, after treatment, the same amount of carbon dioxide it had from its source. A water carbonated with added gas is carbonated water or seltzer. See sparkling waters compared.
Well, ground and sterile water
Well water comes from a hole bored or drilled into an aquifer, and ground water from an underground source not directly influenced by surface water. Sterile water meets the US Pharmacopeia's sterility tests.
Other label lines
- "From a community water system" or "from a municipal source": water from a city supply that hasn't been treated to the purified definition must say so.
- Alkaline water isn't an FDA category. It's usually purified water with minerals or electrolytes added to raise its pH. See alkaline bottled water.
- Fluoride: added fluoride is capped at 0.7 mg/L and must be listed. See fluoride in bottled water.
- Infant water: if a label suggests the water is for infants and it isn't sterile, it must say "Not sterile. Use as directed by physician or by labeling directions for use of infant formula."